Yayınlayan Alpim42 2008/2/10 (2933 okuma)


[You must be registered and logged in to see this image.]Make a cylinder with the settings of picture 1 and picture 2
[You must be registered and logged in to see this image.]Then convert to an editable mesh by right clicking
[You must be registered and logged in to see this image.]Selectthe outside polygons (squares) but missing one each time you shouldhave 5 squares selected rotate with the tool at the bottom (see pic)
[You must be registered and logged in to see this image.]Then scroll down the editable mesh menu and tyoe 100 into extrude THEN -4 into bevel
[You must be registered and logged in to see this image.]Select the middle polygon by clicking on it
[You must be registered and logged in to see this image.]Type into the extrude box -0.1 and THEN into bevel -10
[You must be registered and logged in to see this image.]Extrude -10 THEN bevel -4
[You must be registered and logged in to see this image.]Then extrude -0.1 THEN bevel -12
[You must be registered and logged in to see this image.]Extrude 6 THEN bevel -2
[You must be registered and logged in to see this image.]Select the ends of the spokes and extrude 4 THEN bevel 2
[You must be registered and logged in to see this image.]Thenapply a mesh smooth by clicking on the blue rainbow, scrolling down themodifier list and selecting Mesh smooth. Then set Sub division mode toClassic and Iterations to 2
[You must be registered and logged in to see this image.]You should have a pic like this now
[You must be registered and logged in to see this image.]Make a tube with a radius1 of 140 a radius 2 of 150 and height as 100
[You must be registered and logged in to see this image.]Then apply a mesh smooth
[You must be registered and logged in to see this image.]Then make 2 more duplicates but thin and put on each side of the wheel
[You must be registered and logged in to see this image.]finished]